Case studies

Van roofs longer than 3 meters: a transport solution consisting of 4 thermoformed parts

The customer's challenge
The challenge

The customer's challenge

An automotive components manufacturer supplies van roofs to its customer’s assembly plant. They are large-format parts, more than 3 meters long, with a visible surface that cannot take a single mark.

Until then, it transported them in metal cages with separators. They were heavy, marked the roof at the support points and took up as much space empty as full on the return trip.

Critical factor: at that size, a single thermoformed tray required an oversized machine and mould. The tooling cost could not be justified for the production run.

Critical factor: at that size, a single thermoformed tray required an oversized machine and mould. The tooling cost could not be justified for the production run.

Solution

CTE's solution

CTE proposed splitting the transport solution into four thermoformed modules that fit together to form a single base. Each module reproduces the geometry of the roof in its area, so the part rests on its entire surface rather than on specific points. Guides along the edges align the modules without any bolts.

At the four corners, corner pieces with centring pillars close the assembly and allow loaded units to be stacked. Because the modules are symmetrical in pairs, two moulds are enough, and each part fits in a conventional thermoforming machine. When empty, the unit is taken apart and the modules nest inside one another for the return trip.

The result: roofs that arrive without marks, a unit lighter than the metal cage and a return trip that takes up a fraction of the space.

4 modules

assembled without bolts

0 marks

on the visible surface of the roof

–70 %

less volume on the return trip

Advantages delivered

01

Large format on a standard machine: splitting the unit into modules avoids oversized moulds and machines.

02

Contained tooling: symmetrical modules, two moulds for a unit more than 3 meters long.

03

Continuous support, no marks: the part rests on its entire surface, not on contact points.

04

Stackable and returnable: the corner pieces allow stacking when loaded, and the modules nest when empty.

05

Repairable module by module: if one part is damaged, only that part is replaced, not the whole unit.

Do you have a project?

Let's talk

Tell us what you need. Within 48 hours we give you technical guidance and a no-obligation quote.

To top